GT-90003 - On & Off Car Brake disc lathe (Skimmer)

  • Sale
  • R 41,799.00
  • Regular price R 46,799.00


Description:

On-car & off-car type Car brake disk cutting machine

It’s a luxury model of car brake disc machine.

It’s on-car & off-car type, no need use the car lift.

Duel side cutting when work on brake disc, about 8 minutes per disc. Easy to operate 

Technical Information:

Working height min/max: 850 /1200mm
Rotation rate: 120r/pm
Decelerate motor voltage: 110v/220v50-60hz
Weight: 135 kg
Ambient temperature range: -20 to 50°C
Maximum diameter of brake disc: 510mm
Cutting accuracy of brake disc: 0.01-0.02mm
Maximum thickness of brake disc: 43mm
Brake disc surface roughness: less than 0.15-0.02mm

 

 

Safety first! Make sure you are using the appropriate PPE, safety shoes, safety
glasses, ear protection & gloves.

A brake lathe is an efficient tool for curing noise and vibration problems, often prolonging the life
of brake systems. Basically, brake lathes correct thickness variations on the rotor. Machining discs
with the on-car brake lathe delivers improved braking performance for customers, eliminates brake
vibration and excessive noises, and removes rust and corrosion.

STEP 1: ADAPTER
Clean contact surfaces then fit the adapter using the
correct wheel bolts (30Nm of torque). DO NOT use an
Impact wrench.


STEP 2: LATHE SET UP
Set the lathe to mid-height of gas strut and adjust vehicle height to the lathe. Attach machine to adapter
and tighten the large knob by hand. Position the cutting head with arms in line with disc (A). Ensure dovetail
is tight and secure mounting bolt. Then check for any obstructions before winding the head outwards so the
tips just clear the disc (equally on either side). Set ‘Stop’ switch (B) and lock trolley handle (C).

STEP 3: RUN OUT COMPENSATION
Start machine via on/off switch on motor and press the start button until the red adjusting light flashes. DO
NOT disturb lathe or vehicle during this process. Green lights = ‘Finished compensation’ and ready to go.

STEP 4: CLEAN UP AND FINAL CUT
With the lathe still running, feed the cutting head in approx 10mm. Adjust arms until the tips contact the
disc on both sides. Tighten the ‘Butterfly’ on the cutting head and ‘feed out’ until lip on the edge of the
disc has been removed. Feed in until disc faces are ‘rough cut’ to same thickness (A). TAKE CARE not to hit
disc centre. Loosen the ‘Butterfly’ knob and adjust cutting heads for final cut – minimum 0.004” (0.1mm) to
maximum 0.020” (0.5mm). Stop machine and fit silencer (B). Start machine and push in auto-feed knob to
engage for final cut (C).